Standar Equipment

• Firm metalic stracture 
• Working area 3.1m x 1.2m
• 2 servo motors at Υ axis 
• 1 servo motor at Χ
• 1 servo motor at Ζ
• 8 bearings suport the bridge, 4 bearings at each side (be aware  that most machines use only 2 bearings at each side) 
• Special system quarantees the perfect engage between rack and pinion 
• All moving parts are covered by special items, limited need for meitenance 
• Servo motors at all axis, 4hp each
• servo with encoder 80.000ppr and 200.000ppr
• Accurancy (via mathematic equasions) 0.00108mm and 0.000435mm (acording to encoder)
• Repeatability 0,0009625mm
• Accurancy measured with a digital instrument 0,05mm 
• Smallest axis movement 0.001mm
• Moving and operating speed 25m/min
• Bearings at all axis 
• All cables are protected by energy chains
• Digital switches at all axis 
• Special cables with reduced EMC noise 
• Special covers at the end of the working area keep the dust away from the moving parts
• Spindle with SKF bearings
• Spindle power 6hp, 24.000rpm
• Spindle is controled via inverter and keeps the speed steady even under pressure  
• Spindle speed in controlled via the operating software  
• Capable tool shank diameter 0.1mm to 20mm
• Capable tool (endmill) diameter 0,1mm to 60mm 
• Control made out of  ΑΒΒ electronics 
• Vacuum system useing a dry operating vacuum pump of 2hp, limited need for maitenance 
• vacuum system outputs  1000kg of holding force  
• Special engaved vacuum table  
• Embeded PC with a  19'' touch screen at a stand alone control tower 
• machine can operate in  2D, 2,5D & 3D
• The operating software inspects the machine at all times and outputs error messages displaying where the fault is   
• The software generates  2D, 2,5D g-code out of DF files. the user can choose between : Drill, pocket, engrave, offset with tool radious compensation.
• Speendle speed and cutting speed can be adjusted even when the machine is in operation
• The software reads operating speeds and spindle speeds from the G-code
• During operation the machine can be paused or stopped and then it can continue the operation from the same point 
• Emergency buttons.
• The machine can operate 7/24
• Can operate in any material such as wood, plastics, metals, stones.
• Low power consumption
• Almost zero maitenanse needed 
• Power 380V 3-phase
• Weight 1200kg
• operating cost including maitenance and electric power ~1 €/h

Optional Extras

• Dust suction 
• Special suction foot, it  locks and unlocks earry easy and quick so the tool change will be a matter of seconds
• CAM software for 3D operations 
• Spindle update up to 12Hp    

   

   

  Router dimensions (LxWxH)	3,5m x 1,5m x 1,6m
  work area (LxWxH)	3m x 1,3m x 20cm
  Precision (X,Y,Z)	0,05 at all axis
  Repeatability precision	0,00964 at all axis
  Maximum operating speed	25.000mm/sec
  Number of motors per axis	2 at Y axis, one at X and Z axis
  Motor power	Servo motors 4hp each
  Spindle	6hp (ATC optional up to 16 tools)
  Control	3 to 5 axis
  vacuum system for piece hold	Automatic or manual
  Vacuum system	2hp (6hp optional) motor
  power supply	380Volt
  Weight	1200kg

   

   

   
   

   

  more video here